National-cart CCS-2766-0597B METAL COVERED CART CORRAL Bedienungsanleitung

1 DOUBLE ENTRY 30ꞌ BLUE COVERED CART CORRAL (PART NUMBER 8030401) PACKING LIST AND ASSEMBLY INSTRUCTIONS 3125 Boschertown Road, St. Ch

10 DOUBLE-ENTRY COVERED CART CORRAL ASSEMBLY INSTRUCTIONS *LETTERS CORRESPOND TO ITEMS AS SHOWN IN PACKING LIST* Required Tools: 5/16” Nut driver

11 4. Place remaining headers (C) over sleeves at positions H1, H2, H3, H4, H6, H7, H8 & H9 (Diagram A) on base angles (A). Secure with compone

12 METAL ROOF ASSEMBLY 7. Lay out edge of first maxi rib panel (E) at top of header (C) flush at location H1 but overhanging at location H5, with r

13 12. Install one “J” channel (F) per 15’ section, repeat on other 15’ section, secure at locations H1 through H9, using #12 x 1” tek screws makin

14 B. Making sure that the “H” channel is centered on the header put the second screw in the bottom hole. DO NOT OVER TIGHTEN C. Put “C” c

15 F. Secure polygal panels with the hardware provided F1 F2 (inside of unit) F3 G. There will be tw

16 H. Slide the remaining polygal panels up through each side of the remaining “H” channels and secure with ¼”-20 x 1” HHCS. 15. Repeat step 14 f

17 ANCHORING CORRAL ASPHALT SURFACE (Using “J” Anchors) Required Tools: 9/16” hand wrench Power drill 9/16” socket wrench Pry bar 8”

18 CONCRETE SURFACE NOTE: Use ½” X 5 ½” wedge anchors (provided by others) when installing on a concrete surface. Required Tools: 9/16” hand wrench

19 DIAGRAM A

2 TABLE OF CONTENTS DESCRIPTION PAGE TOP LEVEL DRAWING 3 PACKING LIST 4 - 9 ASSEMBLY INSTRUCTIONS

20

3

4 QTY PACKING LIST 1 Item Part # Description Qty. A 2030144 BASE ANGLE ASSEMBLY 4

5 Item Part # Description Qty. D 1030002 CENTER HEADER ASSEMBLY 1 E B000274 BLUE MAXI RIB STEEL SHEET 29GA 38.50x180" 8

6 Item Part # Description Qty. G B000277 OUTSIDE ANGLE TRIM, BLUE 2 H B000971 POLYGAL PANEL 31.75" X 44" CLEAR

7 15' HARDWARE KITS: 2 of following kits: Hardware Qty. per kit Part # HEADER ASSY. HARDWARE KIT K HEX HEAD SC

8 BASE PLATE ASSY. HARDWARE KIT P FLAT WASHER, 1/2 x1.38 x 9/16” USS ZN 16 B000075 Q J-BOLT, 1/2-13x8", (2” HOOK) 8 B000217

9 POLYGAL ATTACHMENT HARDWARE KIT V HEX HEAD SCREW 1/4-20 x 1.0" GR5 ZN 128 B000259